Throughout my many years of military service I was privy to using a wide variety of Pelican cases. Although, I never had to pay for one, I was aware of their expensive price points. Comparing this Condition 1 to the SiGi brand, I must admit, I am very impressed. For this particular model, it includes three layers of customizable foam. Each layer is approximately 1.5 inches thick. Each layer is made up of small removable squares (measuring .5 inch X .5 inch X 1.5 inches). Beyond the three customizable layers of phone sets one solid phone piece attached to the bottom of the case and another attached on the inside of the lid. The case also features for locking levers (with various external holes to secure with locks) and one decompression valve. In my pictures you'll see I was able to fit my DJI Ronin SC gimbal with its accessories, perfectly in this case. Granted, being I made no cuts and Strictly remove the foam squares to the shapes sizes and depths necessary, Some parts of my equipment don't fall perfectly snug into place. If you're somewhat of a perfectionist asylum, and depending on the amount of equipment's shape and depth complexity, You may want to clear up a few hours of your schedule to get your things set up just right. The case by no means feels cheap nor does it look it. This particular case it's much cheaper in price than one of very similar size from the SiGi brand and doesn't sacrifice quality. I would consider this case perfect if the customizable foam squares were smaller in thickness, not the 1.5 inches they currently are. If they were thinner it would allow for much more precise customization. Besides that, there isn't much difference between those two cases. I STRONGLY RECOMMEND getting this case! Best of luck on your purchase!
